Comentarii la: NU mai putem sta aici! Navigați cu YABA spre salvare! // LAHAKAI Ep11

De: Dustin Frost

Dustin Frost — Wed, 14 Dec 2022 19:03:04 +0000

Talk like a scripted poet

De: John Scarborough

John Scarborough — Wed, 14 Dec 2022 15:24:49 +0000

Since your boat is probably now very top heavy, have you considered adding temporary ballast to keep it from rolling over on the trip South? Something easy to remove maybe sand bags or 55 gallon barrels filled with water.
I like options and also plan to have a short vertical lip added to back edge of swim platform so I can clamp on my outboard motor for emergency use.

De: Chip Seal

Chip Seal — Wed, 14 Dec 2022 12:01:45 +0000

I am a subscriber. Any friend of Yaba is a friend of mine!

De: Frank Meijer

Frank Meijer — Wed, 14 Dec 2022 10:20:16 +0000

Do not sandblast get a tercoo disk and a powerdrill. We did an 8 meter steel ship with two people in a week and used 2 disks. Budget tip from another lost soul.

De: BIll Lippincott

BIll Lippincott — Wed, 14 Dec 2022 09:20:15 +0000

I am hooked! looking forward to following your dreams and outlook on life goals and dreams. Best wishes from Boston. Also a fan of Ben & MP who I was able to meet at the Annapolis Boat show in October.

De: Larry Rayner

Larry Rayner — Wed, 14 Dec 2022 09:09:48 +0000

Great to see Ben !!!

De: Ken Larkin

Ken Larkin — Wed, 14 Dec 2022 08:11:22 +0000

You might consider installing some internal ballast to get your displacement up a bit. Being empty of her interior makes her sit high in the water and raises her center of gravity increasing her tendency to roll. Fairwinds and calm seas.

De: David Medley

David Medley — Wed, 14 Dec 2022 05:12:57 +0000

Great videos! Why are you putting so many anodes on the boat? If you have to many you can set up reverse currents an you may start losing paint below the water line.

De: Walter Howard

Walter Howard — Wed, 14 Dec 2022 04:25:40 +0000

It's not done ! Wow if you only knew, I had a steel 50' cutter-rigged sailboat , the work is never done. I suggest drill all the holes your going to drill in the steel and finish all the welding that is needed , then disassemble everything down to just the steel , and here's were the fun begins, start in the bow sand blast all the way to the stern with out stopping as soon as that's done start with the epoxy primer , stem to to stern and then the outside same thing ! Top coat inside and out then reassemble ! And then you've got about 10 years and you've got to do it all again ! I didn't have the energy to do it twice , I sold mine at the 8 year mark !
I got out just in time , but I'm rooting for you I can't wait to see your finished boat sailing and experience some of the adventures you're going to take ! I'd say good luck but the truth is it takes hard work and a little bit of planning and a giant chunk of cash .Have fun people !

De: Nolan Mailhos

Nolan Mailhos — Wed, 14 Dec 2022 00:26:57 +0000

I'm kind of in the same boat y'all are. I have a 35 ft fiberglass boat that I have to totally gut. Because of termites hate everything inside. The rigging's good. Haven't got to the motor yet. Because of the debris in the way. And I'll run out of money so I can get a job now. Wish I luck.