Comentarii la: A Taste Of Ripping 3 Kilometers Of Cedar – Construirea unei barci cu pânze de 50 ft – Ep. 341 RAN Sailing

De: Thomas Cooley

Thomas Cooley — Sat, 08 Apr 2023 23:06:57 +0000

16:02 look for a air conditioner ductwork that will fit

De: Thomas Cooley

Thomas Cooley — Sat, 08 Apr 2023 23:00:33 +0000

10:10 might want to get a cask iron stove or wood burning heater for the shop use all that sawdust for heat

De: Sarah Pinchbeck

Sarah Pinchbeck — Sat, 08 Apr 2023 21:03:09 +0000

I really love your channel...you make me laugh ..hope to meet you all some day

De: Jeff Wrinkle

Jeff Wrinkle — Sat, 08 Apr 2023 18:43:12 +0000

Power feeder whether new or used is worth the expense. $1000 to efficiently rip 3K of cedar and keep all ten digits is definitely worth it.

De: Jak Mang

Jak Mang — Sat, 08 Apr 2023 15:23:53 +0000

The crack you showed could probably be filled with epoxy and used on a straight section of the hull

De: Jak Mang

Jak Mang — Sat, 08 Apr 2023 15:05:58 +0000

Hope you get a good deal on Shaper tape . Great work.

De: Marie Morrissey

Marie Morrissey — Sat, 08 Apr 2023 00:46:16 +0000

De: Tommy Triglav

Tommy Triglav — Fri, 07 Apr 2023 16:23:39 +0000

Wow That is a beautiful yacht that you are building. Close to my dream too. I was thinking of making it out of bamboo and putting one layer going the length then criss crossing two layers diagonally then a final layer length wise. All glued together with fiberglass resin. So looking at what you were doing I got very excited. I think you can get a perfect fit if you put the wood on the hull with a router space in between. Then routering it out along the length. Then you could fiberglass the two pieces together. They should fit perfectly. Then you can fiberglass the outside. In case the fiberglass on the outside gets damaged then only one board will need to be dried out. So with my four layers should only affect the outside layer.
Not sure if you plan to caulk it or what but with my idea you should get a perfect fit for each board. What do you think????

De: johnnybarbar

johnnybarbar — Fri, 07 Apr 2023 10:24:38 +0000

Amazing quality work so far Johan. Very impressed with your attention to detail.

De: Jay Hays

Jay Hays — Thu, 06 Apr 2023 21:23:57 +0000

You might want to try freecad to design a fitting for your saw dust port and get a cheep PLA printer . Just a thought . Best of luck. cheers.