Pur și simplu punem o torță la toate și apoi mergem la navigație. Actualizări live: facebook.com/sailorama instagram.com/justinesailorama Mulțumim tuturor patronilor acestui canal! Patreon: https://www.patreon.com/sailorama Acceptarea Bitcoin: bc1qcnax827ylqcg0g2ayvygxdg07hyhcwwar5zqsjajehc80allq6tqltnjld Sau pur și simplu lăsați un bacșiș prin Paypal: https://www.paypal.me/sailorama, dacă sunteți în tricouri din Statele Unite, comandați în tricourile noastre. Magazin .link: https://sailorama.merch.link/ În caz contrar, consultați noul magazin de dulciuri: https://teespring.com/stores/sailorama-store Aruncă o privire la Lista noastră de dorințe: https://goo. gl/ejRLZk Camerele pe care le folosim: GoPro Hero 9 Sony A7C iPhone X DJI Mavic Mini Music (utilizați acest link de referință pentru a vă înscrie, iar asta ne ajută să plătim pentru accesul la biblioteca epidemicsound!): https://www.epidemicsound.com /referire/on03eq
source
eșec fierbinte dezordonat navigare
15 thoughts on “eșec fierbinte dezordonat navigare”
Comments are closed.
Was that you strumming the joe Justine?
It's extremely difficult to plastic weld outdoors, that's never going to work.
By the looks of things that kayak might be ABS, not sure you can repair that as it's just too flexible, maybe you can patch a small area but I doubt it would be waterproof.
Oh wow! The aries looks gr8 and you are having a fishing excursion so that's wonderful… don't fret the kayak repair until we can get you some gflex epoxy… it really does work and I have salvaged big kayaks with major cracks…
Absolutely love the hat Justine and of course the bread made me drool!
💗
Tray a zip tie and melt it over the crack so the zip tie macks a puddle over the crack and so on and so on until the crack is sealed and do another process with the big bits of plastic over the top of the crack bit like a plaster like what you put on your f-ing to make it stronger as well you can put also fibreglass or the top of it as well Foster just trying to help good luck
I seen a video of a plastic boat cut in half and glued together with g-flex and seemed to work.
The style on this video is great, keep this style as a change up every once in a while. You are developing as a video story teller very good.
Can you get GreatStuff spray foam there? If so, then drill a few small holes and then fill the air gap with the foam. The stuff uses water to cure so may work. This for the dinghy.
We love your video's keep them coming please ! Thank you !
Love the hat!😊
Thanks
Maybe, spray foam insulation inside? And then a plastic welder
The combination of the big floppy hat and your long curly hair pulled to the side looked lovely. Good luck on your adventures.
Idea from outside the box. We use it 🙂 Hard bottom from fiberglass dinghy (no double bottom). Where you will be able to find for sure some denflatables. Tubes off and instead walls from fiberglass. Walls from polyester so it's not so expensive. If you need any tips or tricks we done three of those already. Keep it going !
Duct tape over the cracks, should leak less. Replace the tape frequently.
?